$75
Used to create an event, or interrupt signal after the step of the pedal signal input.
A signal or pressure input starts the set time delay. The Timer then outputs, and maintains the output until the input signal or pressure ends to reset the positive timer. Output turns off and all output pressure is exhausted through a vent port on the top of the positive timer.
This fully machined billet aluminum timer is used in a majority of racing air operated management systems. Repeatability is 1/100 of a second. Timer is “bubble tight” tested. 125 psi. is maximum input pressure! Stainless steel adjustment needle has 64 threads per inch to allow easier adjustment. All ports are taped 10-32 female to fit a variety of input / output fittings. Timer is supplied with a “volume port”, to add volume to allow for easier adjustments for longer time outs. Measurements are .990″ wide, by 1.250″ deep, by 1″tall, and is supplied with two aluminum 6-32 x 1″ Allen head cap screws to fasten to a logic strip, or logic board. .02 to 2.00 second normal timing span. Anodized jet black finish.