$195.00 USD
For puck and articulating indicator arm, with a micro adjustment head.
$279.00 USD
For 50 millionths indicator. (shown in picture)
$611.25 USD
For 25 millionths indicator
So you think your clutch plates and floaters are flat?
I developed this tool to solve the difficult job of checking the flatness of fresh ground, or new floaters. If you are using a micrometer to check to see if the plate is parallel, that does not prove it is flat!!! A spherical washer measures the same thickness in all places, but it is not FLAT!!! A ‘straight edge’ only checks a ‘single plane. You must start with a known flat surface to measure taper, parallel, and or flatness. Using a good quality inspection grade granite surface plate, this tool with its cast iron puck allows inspection of flatness to within 25 Millionths of an inch, (1/4 of a tenth of a thousandth of an inch.)
Total ‘span’ of the highly precision 50 millionths indicator is .004″, plus or minus .002″, (two thousandths of a inch).
Total ‘span’ of the ultra precision 25 millionths indicator is .002″, plus or minus .001″, (one thousandths of a inch).
Both indicators have over travel protection to prevent over travel damage.
Comes in a padded, sturdy black plastic case.